GMV Components

Blain valves for hydraulic lifts – excellence in simplicity and performance.   Visit Website: Blain Hydraulics

nstalled in the cylinder line between the control valve and the ball valve, the Q10 Flow Meter measures the rate of flow of hydraulic fluid to and from the cylinder. According to the ram size, accurate measurement of car speeds including accelerations, decelerations and stops are assessed by the electronic card, fed to the PC / Laptop and displayed as travel-graphs. Any irregularity of the movement of the car, such as over-speeding, prolonged leveling or abrupt start and slow down movements indicating potential problems can be registered on site or can remotely monitored through modem connection. Printouts of the results provide valuable records of the installation. Sensors for registering system pressure and temperature are optional.

• measures the rate of flow of hydraulic fluid to and from the cylinder
• accurate measurement of car speeds including accelerations, decelerations and stops are assessed by the electronic card
• any irregularities are viewed via PC/laptop
• registered on site or remotely monitored via modem

Visit Website: Blain Hydraulics

The R10 rupture valve can be mounted in any position directly onto the cylinder inlet. In the event of failure in the main cylinder line or where the down speed exceeds allowable limits, the R10 valve closes and brings the car to a smooth stop. Visit Website: Blain Hydraulics

Submersible electric motors for hydraulic lifts. Visit Website: Elmo

SB Motori submersible single and 3 phase motors are specifically designed for immersion in oil to work with submersible screw pumps and meet the requirements of low noise level and high efficiency in hydraulic lifts. Visit Website: SB Motori

SM pumps are three screw pumps for industrial use at low and medium pressure (80 bar). SM pump is a priming pump assembled into a pump body. The three screws rotate inside the pump body and the design of the screws avoids any axial load. The functional pressure develops some tolerances between the balancing piston of the main screw and the surrounding body. This creates a balancing hydrodynamic force on the screws and at the same time lubricates and cools down the sealing parts. The torque needed to move the lateral screws is transmitted hydraulically by the pumped fluid. This means that the screws rotate with no possibility of wearing.

• For industrial use at low and medium pressure (80 bar)
• Reliable low noise instrument
• Long lift pump at low cost

Visit Website: Settima